Connecting the Agitator Shaft to the Agitator drive head

⇐ Предыдущая 8 9 10 11 121314 15 16 17 Следующая ⇒

	CAUTION
Tighten all threaded joints with the prescribed torque values (→ table chapter 4.4)

● Pick up the agitator drive (lifting procedures → chapter 4.1) ● Place the gasket ● Remove the flange cover from the bearing shaft ● Make sure that the mating surfaces are free from dirt and damage ● Lower the agitatordrive onto the agitator shaft ● Connect the agitator shaft to the bearing shaft with 2x screws, nuts and locking plates ● Lift the agitator drive a little ● Remove the wooden beams ● Attach the remaining locking plates, screws and nuts ● Center the flange seal ● Tighten the flange joint crosswise with half the final torque value

● Bend the corners of the locking plates

● Tighten the flange joint crosswise with the full final torque value

⇐ Предыдущая 8 9 10 11 121314 15 16 17 Следующая ⇒

Не нашли, что искали? Воспользуйтесь поиском:

vikidalka.ru - 2015-2024 год. Все права принадлежат их авторам! Нарушение авторских прав | Нарушение персональных данных